Skip to main content
Fast, Reliable Electrician & Security — Call Now: 0414 464 675
Licensed Electrician & Security Agent · EC12377 / SA54405

Alarm Repairs
Perth

Alarm beeping, refusing to arm, or going off at three in the morning? Ness and Bosch panels, homes and small commercial, across Perth metro, by an electrician who is also a licensed security agent.

How a Repair Is Charged

A repair cannot be quoted at a fixed price the way an installation can, because nobody knows how long a fault takes to find until it is found. What can be set out up front is how the charge is built: an attendance covering the travel out to you and the first half hour on site, then time in increments after that, plus any parts the repair needs.

Half an hour is enough to diagnose most alarm faults. Where the fix is quick, a flat backup battery being the obvious one, it is often done inside that window. Where the repair runs further than the diagnosis, you get a price for it and it does not go ahead until you have agreed to it.

You are told the rate before anyone is booked in, not after the van is in the driveway. Describe what the alarm is doing when you ring and you will also get a realistic idea of what it is likely to come to, which is a different thing from a fixed price and is said as such.

It costs the same to attend whether the answer is a battery or a dead board. What you are buying is a licensed tradesperson finding out which it is, and that part is honest work whichever way it lands. Our terms set out how service work is charged.

What Usually Turns Out to Be Wrong

Three things account for most of the alarm calls that come in:

  • The backup battery. A sealed battery sits in the panel box to carry the system through a power cut. It is a consumable, it does not last the life of the alarm, and a panel that has started beeping for no apparent reason is very often telling you about it.
  • A detector. One sensor failing, sitting in permanent alarm, or triggering on nothing will stop the system arming or wake the street at night. Replacing the one that has gone is straightforward.
  • The panel itself. The one case where repair is usually the wrong answer, and the section below is about why.

Alongside those: a keypad that has stopped responding, a siren that will not reset, a system nobody has the code for, and a panel disconnected years ago that somebody now wants working again before they sell.

Why Call Dextel for a Fault

Licensed Both Ways

Electrical Contractor EC12377 and Security Agent SA54405, so the power side and the security side are the same visit. $10 million public liability insurance.

The Rate Comes First

You get the rate and what it covers before anyone is booked in, so the first time you hear a number is not when the work is already done.

One Tradesperson

The same person who answers the phone turns up and does the work. No call centre, no subcontractor you have never spoken to.

Same-Day Response

A reply the same day, with the visit worked in around jobs already booked.

When the Panel Is the Fault

A battery or a detector gets replaced and your alarm goes back to doing its job. That is a good outcome and it is a fair share of these calls.

The panel is different. When the board itself has failed, the position is not that nobody could fix it, it is that fixing it rarely makes sense. Parts for a board that went out of production years ago are not sensibly available, and the hours it takes to chase a fault through one can cost more than the system is worth. You would be paying good money to return an ageing panel to the state it was in before it broke, which is still an ageing panel.

So where that is what the diagnosis shows, you get told on the day, with a price for a retrofit instead of an open-ended repair. The detectors and cabling already in your walls usually carry over, which is what keeps a retrofit well under the cost of starting again. How a retrofit works, and what carries over →

None of that is decided before anyone has looked at it. Plenty of alarms that owners had written off needed a battery.

Ness and Bosch

Those are the two makes this service covers. Between them they account for most of the alarms sitting in Perth homes built or fitted out over the last few decades, and they are the two boards worth knowing properly rather than guessing at.

If what is on your wall says something else, ring first and tell me what is written on the keypad. It is a two minute conversation and it saves an attendance fee spent on a panel that cannot be opened up. Where a system has been locked by the installer who put it in, that is worth saying on the phone too, because it changes what is possible on the day.

New systems are a separate thing from repairs and are quoted at a fixed price, not charged by the hour. Ajax alarm systems and what they cost installed →

Alarm Repair FAQs

What does it cost to have someone look at my alarm?

Repairs run on a service rate rather than a fixed quote, because nobody can say how long a fault takes to find until it is found. The attendance covers the travel and the first half hour on site, which is enough to diagnose most alarm faults, then time in increments and any parts used. Tell me what the alarm is doing when you ring and you get the rate and a realistic idea of the cost before anyone is booked in.

Which alarm panels do you work on?

Ness and Bosch. They are the two panels in most Perth homes of a certain age and they are the two I know properly. If yours is something else, ring and tell me what is on the keypad before booking anything, because turning up to a panel I cannot get into helps neither of us.

My alarm is beeping and will not stop. What is it?

Most often the backup battery. It is a sealed battery inside the panel box that keeps the system alive through a power cut, it is a consumable rather than part of the system, and it is the single most common reason an alarm starts complaining. It is also the cheapest thing on this page to put right.

Can you fix it, or will you just tell me to buy a new system?

A flat backup battery or a failed detector gets replaced and the system goes back to working, and that is a large share of the calls. Where the panel itself has failed the honest answer is usually different, because parts for a twenty-year-old board are not sensibly available and the labour to chase a fault through one costs more than it returns. In that case you get told so on the day, with a retrofit price rather than an open-ended repair.

Do you charge a call-out fee on top of the repair?

There is no separate call-out charge stacked on top. The attendance covers the travel and the first half hour on site, and it is the same whether the answer turns out to be a battery or a dead panel. You are paying for someone licensed to find out which it is, and that is the part nobody can quote blind.

How soon can you come out?

You will hear back the same day by call, text or email. A same-day visit is not promised, because the honest answer depends on what is already booked. When the call back comes you get a real time rather than a window with nothing behind it.

Can you take over an alarm another company installed?

Yes, provided it is a Ness or Bosch panel and it is not locked to a monitoring contract you are still inside. Bring the keypad code and any paperwork you still have. Where a panel has been installer-locked, say so on the phone, because that changes what can be done on the day.

Alarm Repairs Across Perth Metro

Dextel is based in Spearwood and works across Perth metro. A small service call a long way from Spearwood is worth a word on the phone first, because half an hour of work cannot carry an hour of driving each way. Where we work →

Service work under $1,000 carries no deposit. Our terms →

More on Ageing Alarms

Alarm Playing Up?

Tell me what it is doing and what it says on the keypad, and you will get a straight answer about whether it is worth attending. Replies go out the same day.

Call Now